These pages have not been proofed for accuracy. Please use the
information at your
The Key to Atomizing successful Results is knowledge of the
techniques of Conventional and Atomic Air Blasting and Gun Blasting
and the Power of Atomization and Air Blasting.
Back to Contents
Conventional and Atomic Air Blasting and Gun Blasting
This manual has been produced with the expectation that the reader will be familiar with a certain amount
of conventional blasting and blasting with compressed air.
The production of any construction related to rock excavation may be defined as
a conventional blasting operation. Typically, a conventional blast
operation is used to remove obstacles in pre-existing underground
building sites or for the excavation of shallow pits or holes for
construction. As used in this document, a conventional blasting
operation is used to refer to a blasting operation where the explosive is
fired into the “rough-cut” face of a rock or rock formation.
Firing into the “rough-cut” face of a rock or rock formation is
commonly referred to as “face blasting.” Typical face blasting
rock faces are loose soil, gravel, clay, and sandstone rock.
Face blasting with explosives is a relatively simple operation,
even though the success of the operation can be seriously hampered
by misinformation. In fact, some conventional blasting using
explosives is so unsafe that it should never be attempted.
This Manual is an attempt to present the basic fundamentals
of blasting for safety and practical success. However, neither
this manual nor any other manual can replace on-site training
and experience. For that reason, the reader should not attempt
face blasting without proper training and experience. This
document does not provide any safety precautions, only basic
principles and instructions on proper blasting technique.
The preferred blasting method is tunnel blasting to be used
for blasting in the vicinity of a tunnel or passageway. Face
blasting is usually a technique used to accomplish rock removal
with open face or high angle blasting. Face blasting can be a
simpler blasting operation than tunnel blasting because of its
one-way advantage. Although there are some advantages to
face blasting, there are also some drawbacks,
The greatest drawback to conventional face blasting http://gintenkai.org/?p=491
Download. The file length cannot be more than 2000 bytes. More Kasumi Rebirth V30 Cracked: Related.